Support Board

• Support Board |
• Search Board |
• Control Panel |
• View My Posts / Threads |
• Direct Messages

Date/Time: Fri, 27 Mar 2026 03:26:21 +0000

Study Subgraphs Reference study returns/references incorrect values

View Count: 860

[Page 1 of 1] First Page -- 1 -- Last Page

[2022-12-16 18:07:14] #1 [Go To First Post]
Sawtooth - Posts: 4321
The Study Subgraphs Reference study is used for shading between two subgraphs that are not in the same study. However, this study seems to return the incorrect values, and the shading does not match the referenced subgraphs' values. The attached Reference of two lines.png shows two lines at 3900 and 3910, but the shading is from 3864 to 3932 The attached Reference of tow MAs.png shows the shading above the higher MA and below the lower MA. Note: The Study Subgraph Reference study accurately returns the referenced subgraph's value. Please advise.
0x Thank you
Reference of two lines.PNG / V - Attached On 2022-12-16 18:05:31 UTC - Size: 32.71 KB - 162 views Reference of two MAs.PNG / V - Attached On 2022-12-16 18:05:43 UTC - Size: 48.6 KB - 159 views

[2022-12-16 18:21:59] #2 [Go To First Post]
John - SC Support - Posts: 45313
Set the scale of the Study Subgraphs Reference to "Automatic". Refer to the following: Chart Studies: Settings and Inputs Tab >> Scale For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing
1x Thank you

[2022-12-16 21:40:38] #3 [Go To First Post]
Sawtooth - Posts: 4321
You would think that would be the default.
0x Thank you

[2022-12-16 21:47:18] #4 [Go To First Post]
John - SC Support - Posts: 45313
You can make it the default by using the Set Defaults option. Refer to the following: Chart Studies: Using Custom Default Study Settings For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing
0x Thank you

[Page 1 of 1] First Page -- 1 -- Last Page