Login Page - Create Account

Support Board

Date/Time: Thu, 18 Aug 2022 10:58:36 +0000

scale-in/scale-out and oco qty

View Count: 1257

[2013-06-04 21:41:50]
Bedhog - Posts: 163
Hello Support,

This has always worked and it may be my doing, but I believe it stopped after updating to 982.

I trade with 2 charts open and each chart has its own trade book.

I use ChartA to make an entry and it is set for 2-lots, Use Attached Orders, with Scale-in/Scale-out enabled.

I use ChartB to perform the actual scaling using a qty of 1. Use Attached Orders is not selected and Scale-in/Scale-out are enabled.

Prior to the update, I could scale-in and scale-out with ChartB and the OCO would always reflect the current position size.

At the moment, scale-in/scale-out from ChartB does not update the OCO quantities.

Thank you.

[2013-06-05 07:39:25]
Sierra Chart Engineering - Posts: 104220
Some brief testing did not indicate a problem.

Scale In requires that Use Attached Orders is enabled. Scale Out does not require it. Please refer to the documentation here:
Sierra Chart Support - Engineering Level

Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy:

For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service:
Sierra Chart Teton Futures Order Routing

To post a message in this thread, you need to log in with your Sierra Chart account:


Login Page - Create Account