Support Board
Date/Time: Fri, 09 May 2025 19:31:58 +0000
millisecond question
View Count: 901
| [2015-04-17 16:55:09] |
| onnb - Posts: 663 |
|
I had a chart where the ms portion for each bar was always 0 even though the bars were the same second. I was not connected to the data feed at this time. I then connected to the data feed and did a full reload/recalculate and the ms portion started to appear. Any idea why this is? Are there any special conditions that need to be met in order for the ms numbering to appear? |
| [2015-04-17 17:33:56] |
| |
|
We really have insufficient information. We would have to have the chart data file and actually test this. In general, what you describe does not make sense. Connecting to the data feed is not going to affect existing data already in the chart. And performing a Reload will not matter either.
Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: