Support Board
Date/Time: Tue, 26 May 2026 08:07:25 +0000
Post From: Secondary grid auto adjust
| [2026-04-16 14:24:13] |
| John - SC Support - Posts: 46260 |
|
The real issue is that the primary grid is changing when you change the scale. The Secondary Grid is set by taking the value you enter and using that number of Primary Grid increments. So for a setup with the following: - Horizontal Grid Line Increment: 10 - Number of Increments for Secondary Grid: 5 You would have a secondary grid displaying at every 5 levels of the primary grid. Which, given that you state that you are seeing the Secondary Grid at every 100 points, means that your primary grid must not be displaying at every 10 points, but rather every 20 points to begin with. Then, when you adjust the scale to compress it, when the primary grid gets too close together, the lines will expand out and the secondary grid along with it. There is no ability to control this in a different way. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |