Support Board
Date/Time: Sat, 22 Nov 2025 17:15:14 +0000
Post From: Rectangle tool configuration TC1/TC2/etc
| [2025-10-07 14:28:28] |
| John - SC Support - Posts: 43119 |
|
If you have the configurations setup as you want and those are working properly (i.e. TC1 gives you a Red Rectangle, and TC2 gives you a Green Rectangle) then it is just a matter of assigning those particular tool configurations to a control bar button for the different control bars. This is done by following these instructions: Chart Drawing Tools: Creating Control Bar Buttons which Select Drawing Tool and Drawing Tool Configuration in One Step For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |