Support Board
Date/Time: Fri, 04 Jul 2025 10:38:37 +0000
Post From: Show Sim orders, Positions & fills on charts using file > new instance
| [2025-06-18 18:17:16] |
| John - SC Support - Posts: 40745 |
|
If the sub-instance had "Simulation Mode On" enabled when the trades were done, then that trading information is only available in that sub-instance. The same is also true for any trading done in the Main Instance - these trades will NOT show in the sub-instance at all - it is a one-way connection. Another option would be to use the "Simulated Futures Trading Service", as this will allow all trading done to be shown in all instances. Refer to the following: Simulated Futures Trading Service For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |