Support Board
Date/Time: Mon, 02 Jun 2025 14:07:49 +0000
Post From: Unable to draw rectangles on one of my instances
| [2025-05-05 17:53:59] |
| John - SC Support - Posts: 40134 |
|
Keep in mind that the Configurations are what are used when the drawing is first drawn. After that, if you bring up the properties for the drawing, then you are viewing the properties for that one drawing - those are no longer the configurations. So you do need to change the setups in the Tool >> Tool Config >> Rectangle Config section to ensure your drawing is what you want. There is not way to change particular options for the configurations through hotkeys/control bars. You get them setup and then can change between different configurations using hotkeys/control bars - if you want. Refer to the following: Chart Drawing Tools: Creating Control Bar Buttons which Select Drawing Tool and Drawing Tool Configuration in One Step For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |