Support Board

Date/Time: Thu, 02 May 2024 16:22:24 +0000

Post From: Delayed data with Denali data feed and CME data

[2023-02-10 23:34:16] Link To Thread - Link To Post [Go To First Post]
John - SC Support - Posts: 31313
You are getting delayed data because you have not logged into your trading account. You need to do this from Sierra Chart. Since you signed up with Edge Clear and IronBeam, you are most likely using the Teton Order Routing Service. In which case, follow the instructions starting at Step #6 at the following link: Sierra Chart Teton Futures Order Routing: Setup Instructions If you do not intend to stay connected to your live trading account, then follow the instructions at the following link to connect once a month: Real-Time Exchange Data Feeds Available From Sierra Chart: Connecting Only Once a Month to Trading Account to Support CME Group Exchange Fees The issue with the Limit order is most likely since you were using the Delayed data, but connecting to the real-time Trading Evaluator. Once you get your real-time data flowing and you are connected to the Trading Evaluator, try again - you should not have an issue. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing