Support Board

Date/Time: Sun, 19 May 2024 08:36:04 +0000

Post From: Converging drawings

[2019-01-03 16:09:57] Link To Thread - Link To Post [Go To First Post]
John - SC Support - Posts: 31704
The information in the documentation is correct. What can be confusing is where you are selecting the drawing. If you are selecting a drawing at the anchor points (the ends for a line, for example), then it will be in Adjust mode, as the system assumes you want to adjust the end point. If you are selecting away from the anchor points, then it is assuming you want to perform a Move. In the situation you describe, which we have tried and verified that it works, if the line ends at the end of the rectangle, and you are selecting at that location, if you select the line number, then it should be in adjust mode. The other option is to simply right-click on the drawing you want to adjust away from where the convergence occurs and select the Adjust Drawing option from the Tools Menu that is presented. You will find the information on doing this here: Chart Drawing Tools: Converging Drawings If you still have trouble with this, then please attach a Chartbook with one chart that contains the drawing tools that you are having a problem with and we will ensure that everything is working properly with those drawings. Follow the instructions here for how to do this: Support Board Posting Information: Providing Chartbook with Only a Single Chart For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing