Support Board
Date/Time: Sat, 31 Jan 2026 07:06:42 +0000
What are the default settings for the Update Interval section
View Count: 28
| [2026-01-30 21:32:33] |
| User357195 - Posts: 185 |
|
I made some changes to the Update Interval portion of the screen located at: Global Settings > General Settings > General and did not write down the defaults that were there before I made the changes. Now, when I start up SC, it takes about 4 minutes for Rithmic to populate the data and begin streaming. Before the changes I made in an attempt to make SC even faster, it would only take about 30 seconds to load and populate the data and then begin streaming. Here is what I have under the Update Interval section of Global Settings > General Settings > General Settings name Update Intervals Chart Update Interval in MS is 30 Quote Board Update Interval in MS is 100 Quote Board High/Low Timeout Time in Seconds is 30 Multiple Chart Back Test Update Interval in MS is 200 Timer Management Enable is No Timer Management - Chart Calculation/Draw Time multiplier for Interval Delay is 3 Timer Management - Maximum Interval Delay in MS is 300 Minimum Delay Between Chart Update in MS is 30 US OS Timer for Charts Yes I made no changes to anything else in this section or to anything else on this whole screen. I attached a screenshot of what I currently have to this support post. What were the default settings for the Update Interval section of the attached screenshot that SC had preset before the changes I made above so that I can put it back? I read the info at General Settings Window: Chart Update Interval (Global Settings >> General Settings >> General >> Update Intervals) Thanks. Date Time Of Last Edit: 2026-01-30 21:44:16
|
 Global Settings - General Settings - General - update interv.png / V - Attached On 2026-01-30 21:21:23 UTC - Size: 253.3 KB - 6 views |
To post a message in this thread, you need to log in with your Sierra Chart account: