Support Board
Date/Time: Wed, 08 Oct 2025 08:16:13 +0000
Rectangle tool configuration TC1/TC2/etc
View Count: 37
| [2025-10-07 06:41:38] |
| User308424 - Posts: 73 |
|
Hello SC support team, I use 2 charts, same symbol, different timeframe. On both charts I use different control bars. Each control bar has option to draw rectangle. Aim is that when I select rectangle from one chart I get the drawing with red filling and when I use rectangle for another chart I get the drawing with green filling. I saved two configurations for rectangle but I am unable to assign tool config TC1 to control bar 1 and TC2 to control bar 2. I dont see any custom names of tool configuration under Tools->Current tool config. Can I kinldy ask to assist? This is not intuitive to me... Thanks. |
 rectangle config.png / V - Attached On 2025-10-07 06:40:56 UTC - Size: 50.69 KB - 7 views |
| [2025-10-07 14:28:28] |
| John - SC Support - Posts: 42262 |
|
If you have the configurations setup as you want and those are working properly (i.e. TC1 gives you a Red Rectangle, and TC2 gives you a Green Rectangle) then it is just a matter of assigning those particular tool configurations to a control bar button for the different control bars. This is done by following these instructions: Chart Drawing Tools: Creating Control Bar Buttons which Select Drawing Tool and Drawing Tool Configuration in One Step For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |
| [2025-10-07 15:22:24] |
| User308424 - Posts: 73 |
|
Hi John, thanks for the answer. Seem copying control bars was the issue. Now all is fine. Thanks very much for the help! |
To post a message in this thread, you need to log in with your Sierra Chart account: