Login Page - Create Account

Support Board


Date/Time: Fri, 07 Aug 2020 09:22:38 +0000



Data Feed

[2014-06-03 14:35:06]
gmorgan111 - Posts: 105 | Ending Date: 2020-10-09

I am subscribed to the SC Data Feed but the feed for the ym nq and 6e is not plotting properly during the night hours when my computer is turned off. There are a lot of gaps and blank areas where there should be bars. The bars do not start plotting properly until I turn my computer back on. This is similar to the other request I sent regarding my cumulative delta bars not plotting when my computer is turned off.

Thanks
[2014-06-03 15:53:46]
Sierra Chart Engineering - Posts: 88421 | Ending Date: 2021-04-05
You need to activate the CME exchange here:
https://www.sierrachart.com/usercp.php?page=SC_RealTime_DataFeed_SetExchanges

After this is done, restart Sierra Chart. Even though you have the data feed activated, you do not have the exchange activated so effectively you are not getting data from the Sierra Chart data yet for this month.
Sierra Chart Support - Engineering Level

Your definitive source for support. Other responses are from users. If possible please keep your questions brief and to the point. Please be aware of support policy:
https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation

If your question/request has been answered and you do not have anything further, then it is easiest for us if you do not reply again to say thank you.

To post a message in this thread, you need to login with your Sierra Chart account:

Login

Login Page - Create Account