Home >> Support Board

Support Board

Date/Time: Sun, 12 May 2024 08:46:51 +0000

How to Post a Message for Support

True range without gaps

View Count: 595

[2017-03-21 07:43:04] #1 [Go To First Post]
EuropeanTrader - Posts: 290
Hi, is there a way I could see the actual true range of these bars (session times applied to one 30min bar) without gap affecting the calculation? http://www.sierrachart.com/image.php?Image=1490082116782.png Thanks!

[2017-03-21 17:17:49] #2 [Go To First Post]
Sierra Chart Engineering - Posts: 104368
You need to use the True Range study: https://www.sierrachart.com/index.php?page=doc/TechnicalStudiesReference.php#s346 Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, change to the Teton service: Sierra Chart Teton Futures Order Routing

[2017-03-22 08:29:33] #3 [Go To First Post]
EuropeanTrader - Posts: 290
Hi, please see attached. Bar A vol is smaller than bar B's. Indicator below takes into account the gap. Is there a way to avoid that, please? Thank you.


sc.png / V - Attached On 2017-03-22 08:29:30 UTC - Size: 80.26 KB - 233 views

[2017-03-22 09:58:16] #4 [Go To First Post]
Sierra Chart Engineering - Posts: 104368
Is there any way to avoid what specifically? Also the True Range study does not use volume in any way. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, change to the Teton service: Sierra Chart Teton Futures Order Routing

[2017-03-22 14:52:39] #5 [Go To First Post]
Sawtooth - Posts: 3995
Use the Study Subgraphs Difference study, set the Input Study 1 to High, set the Input Study 2 to Low, set the Draw Zero to Yes.

To post a message in this thread, you need to log in with your Sierra Chart account: