Support Board
Date/Time: Wed, 10 Sep 2025 13:38:24 +0000
Post From: SC Quits when Paste Large Formula into Spreadsheet Window
| [2016-04-06 20:53:48] |
| User791263 - Posts: 151 |
|
My L Exit had no problem when I added K3=0 to it. I took out 3 lines of formula from K to be sure Size of formula was not the issue. Still quit on add of L3=0 to first line. I tried indirect L3=0 via the only other (duplicate 3-Line chart) sheet 31, putting Sheet37!L3 in its L-col (like the H3 attempt) (this sheet normally has no signals K L M N (no other autotrade) Then referencing Sheet31!L3 from original problem #37 K-col Same failure as using H3 "indirect" That is, both behave exactly like putting L3=0 into K formula. My intrabar AutoTrade settings may invoke your(?) possible internal prohibitions on K testing L before end-of-bar with those settings only? This may happen on M too, testing for N3=0. I need to double check that. SETTINGS on this AutoTrade Ch37: Reset on new bar Yes Allow multiple entries Yes Signal once per bar No Cancel all orders on entry No Allow entry with workin order Yes Signal on Bar close No Support Reversals Yes Allow opposite Entrywith Opp Position Yes |