Support Board

Date/Time: Sun, 19 May 2024 08:47:40 +0000

Post From: Vol Profile problem

[2015-03-17 18:30:32] Link To Thread - Link To Post [Go To First Post]
pismo10 - Posts: 158
Using 1239, ES 1.25 range chart. When i draw a vol profile across a few bars it prints the profile and then when the next tick occurs if often moves the profile back one bar. The thin rectangle that shows what bars the profile is drawn on stays correct but the profile moves one bar. Just started with upgrade to 1239. I Use profile all the time. Thanks