Support Board
Date/Time: Sat, 10 May 2025 22:22:36 +0000
Post From: CIRCLE/ELLIPSE TOOL
| [2015-03-12 18:00:30] |
| michelh - Posts: 159 |
|
Can the Ellipse tool please be fixed so that the points defined are on the diameter of the circle instead of the corners? If I try to draw an accurate arc between 2 points, this is not possible since the current tool defined the corners of a square with an embedded circle and NOT the actual perimeter/diameter of the circle. This would be a very valuable cycle tool. With thanks, |