Support Board
Date/Time: Sun, 04 Oct 2026 08:42:14 +0000
Post From: entries using renko bricks late using Renko visual study
| [2026-08-20 13:57:01] |
| John - SC Support - Posts: 48095 |
|
But the entry happens one bar later. I have tried with limit orders also but no change, What am I missing?
The option "Signal Only on Bar Close" actually means to signal when the next bar starts, as the system does not know the bar has closed until then. Therefore, what you are seeing is correct due to your having set that option to "Yes". ANd noticed that previous close and present open do not always align on the spreadsheet using The renko visual open close study
We are not sure what you are referring to with this. Keep in mind that the Renko Open and Renko Close are different values than the standard Open and Close, therefore, if you are comparing to the Open/Close within the Spreadsheet, then those are not the proper values. Refer to the following: Renko Bar Charts: Renko Open, High, Low, Close Values For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |