Support Board
Date/Time: Sat, 30 May 2026 05:27:43 +0000
Post From: Draw Anchored VWAP - Current Tool Config is not being applied
| [2026-05-27 18:53:45] |
| John - SC Support - Posts: 46361 |
|
Also, we are very confused on how you are moving the anchor point after you draw the Anchored VWAP. In particular, if you are not changing the drawing tool to the Pointer, then you can not select the anchor point and move it directly. You would have to right click and select "Adjust Drawing". Please give us the exact workflow you are using for this. Please do not leave out any steps, so we can understand how this is occurring. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |