Support Board
Date/Time: Sat, 28 Feb 2026 03:04:14 +0000
Post From: Flex RENKO; P&F chart
| [2026-02-27 21:45:38] |
| John - SC Support - Posts: 44849 |
|
We want to verify that you are changing the setting in "Global Settings >> Graphics Settings - Global", closing the chartbook and reopening it, and then you are looking at "Global Settings >> Graphics Settings - Global"? Or are you looking at "Chart >> Graphics Settings - Chart"? We tried the situation where we modified the Graphics Settings - Global, saved and closed the chartbook, then opened it again - and the width of the "Bar High-Low Down" stayed the same. If you are looking at the "Graphics Settings - Global" for the before and after, then it sounds like your "Sierra4.config" file is not being updated for the changes to the graphics settings. The only item we can think of for why this would occur is a lack of drive space to save out the updated file. Check your drive space and make sure you have space wherever Sierra Chart is saving to. The chart type would have no impact on the Graphics Settings - especially when you are changing the Global Graphics settings. Even with the chart graphics settings, the type of chart would not cause things to change in the settings. Are you using any special study to get the Flex Renko? Are you actually looking at the width of the wick and not opening the graphics settings itself when you see the change? For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |