Support Board
Date/Time: Wed, 10 Dec 2025 08:28:32 +0000
Post From: AMP and Teton Order Routing
| [2025-12-09 15:33:15] |
| John - SC Support - Posts: 43381 |
|
It sounds like you have two accounts with AMP, one setup to use Teton and one setup to use CQG. If this is the case, then you need to have two installations of Sierra Chart, one to connect to Teton and one to CQG. Refer to the following for how to install another Sierra Chart: Using Multiple Data and Trading Services at the Same Time: Step-By-Step Instructions to Install Multiple Copies of Sierra Chart You are setup to get the CME exchange data from our Denali Exchange Data Feed, so you will get that data to both installations. You state that you are getting an error of "No Trading Accounts Assigned" when trying to connect to Teton. Is this a recent development? Were you connecting to Teton previously? If so, then this sounds like AMP may have setup both accounts on CQG. You need to check with AMP on the setups for your accounts. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |