Support Board

• Support Board |
• Search Board |
• Control Panel |
• View My Posts / Threads |
• Direct Messages

Date/Time: Thu, 04 Sep 2025 12:29:33 +0000

Post From: Setting imbalances on numbers bars

[2025-08-28 18:07:38] Link To Thread - Link To Post [Go To First Post]
Valtteri - Posts: 1
Hi, I can't figure out how to set up imbalances properly on numbers bars. Here is how it's looking now: [image: image.png] There are way too many, I would like to have the footprint setup the same way as it is right now but I only want to change the imbalance rate to lower. This is how I had it on ATAS: [image: image.png] The imbalance rate was set up to 200. How can I set up the imbalances the same way?
0x Thank you
tmp_1756367712_image.png / V - Attached On 2025-08-28 18:07:31 UTC - Size: 151.49 KB - 17 views tmp_1756367711_image.png / V - Attached On 2025-08-28 18:07:34 UTC - Size: 19.68 KB - 15 views