Support Board
Date/Time: Tue, 06 May 2025 23:00:30 +0000
Post From: Spreadsheet. Multiple entries with limit orders not appearing during same bar
| [2024-12-03 19:09:29] |
| John - SC Support - Posts: 39675 |
|
When you have this occur, open "Trade >> Trade Service Log" and see if there is anything in there related to why the Limit order is not being placed, or maybe why it was rejected. You can post your log to this thread for us to review by following these instructions: Support Board Posting Information: Providing Lines From Trade Service Log If that does not give any information, then you need to look at your Trade Activity Log and see if there is a Limit order being created and what may be occurring with it. If that does not give any insight, then you need to look at your setup and see why the Limit order would not be being created. There has to be a reason for it. In particular, are you setting up specific orders in the Spreadsheet or are you just using what is set in the Trade Window? Is everything set properly to allow the Limit order to be put in place when this second order comes up? What is the timing of this second order, is it occurring very quickly after the close of the first order and could this be causing an issue? For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |