Support Board

Date/Time: Tue, 07 May 2024 09:48:42 +0000

Post From: Access drawing properties whilst

[2023-04-26 15:10:21] Link To Thread - Link To Post [Go To First Post]
cuckiecheese - Posts: 58
The trouble I'm having is that while "support drag on creation" is enabled, after the drawing is created, I cannot seem to select it to apply the config [using my keyboard shortcut]. The only way I have found to apply the config in this situation is to open up the chart properties and load it from there. When "support drag on creation" is disabled then applying config thru hotkeys is no problem.