Login Page - Create Account

Support Board


Date/Time: Fri, 21 Jun 2024 08:14:47 +0000



Post From: I just came over from TradingView with AMP

[2023-01-25 22:52:41]
John - SC Support - Posts: 32500
We see you are currently on Package 12 (Integrated Advanced with MBO). In order to get the Denali data, you need to be on one of the Integrated Packages (Packages 10, 11, and 12), therefore you are fine now in terms of the package (the original package you chose - package 5 (Base Advanced) would not allow you to get the Denali data).

But you need to finish setting up the Denali data for your account. For the CME Group data follow the instructions at the following link:
Denali Exchange Data Feed: *Setup Instructions: CME/CBOT/NYMEX/COMEX Exchanges*

If you need data for the EUREX, CFE, or NASDAQ TotalView, then you would follow the directions at the following link to get these setup:
Denali Exchange Data Feed: *Setup Instructions: All Other Exchanges*

We also see that you are not connected to your CQG account yet. To connect your Sierra Chart to your CQG account, follow these instructions:
CQG Trading Platform Service: Setup Instructions

Once all of the above is setup, then you will be getting the real-time data for the exchanges you want and you will be able to place trades through Sierra Chart to your CQG account with AMP.
For the most reliable, advanced, and zero cost futures order routing, use the Teton service:
Sierra Chart Teton Futures Order Routing