Support Board
Date/Time: Fri, 20 Jun 2025 05:54:10 +0000
Post From: Tool Configuration vs Tool Selection
| [2022-06-09 22:00:18] |
| John - SC Support - Posts: 40526 |
|
This is not the way it works. As you noted, the system is setup to keep the last tool configuration used as the active tool configuration. But, refer to the following information for how to setup a Control Bar item that selects the Tool and Tool Configuration at the same time: Chart Drawing Tools: Creating Control Bar Buttons which Select Drawing Tool and Drawing Tool Configuration in One Step For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |