Support Board
Date/Time: Tue, 24 Jun 2025 00:47:24 +0000
Post From: Locking an individual pull point to a specific part of the candle without affecting pull 2
| [2022-02-09 21:55:15] |
| John - SC Support - Posts: 40583 |
|
There is not a built in option to specifically force one anchor to a position and then force another anchor to another. You would just have to adjust each anchor point individually to get what you want. It can be helpful if you use the Auto Snap option. Refer to the information here: Chart Drawing Tools: Automatic Snapping of Chart Drawing Ends to Open, High, Low or Close Bar Values For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |