Support Board

Date/Time: Tue, 07 May 2024 20:33:15 +0000

Post From: Order Management questions + Commands guide + Customize Buttons DOM

[2020-11-25 16:14:41] Link To Thread - Link To Post [Go To First Post]
MuUs! - Posts: 45
Hello I have an issue with the "Scale in, Scale out" functionalities. As said in post 1, I enter positions using multiple orders, each of which is very very small: for example for a position of Long 100k i will send one hundred(100) 1k orders manually. I want to have the stop loss level a number of pipettes (parameter "Offset") from the first order; as new orders are executed the Quantity of the stop loss should reflect the total exposure. Also, I have a profit target. However I have noticed that if I have "Scale In" and "Scale out" ticked, I get more than 1 Stop loss order(all at same level) and more than 1 target(all at same level); that is not what I need as I only need 1 stop loss with the Quantity=Total position. As it is now, the effect is very problematic because when I want to drag the Stop loss on the chart to make risk tighter I will always drag one of the stop losses only(with Quantity that is different from the total exposure; also there will be multiple stop losses at the original level from which I would like to start the drag..I hope I was clear enough). What are the settings I should have in order to generate only one "Stop Loss" with Quantity = Total position, given the way I send orders? Thanks