Support Board
Date/Time: Sun, 22 Jun 2025 10:48:54 +0000
Post From: Cutting Parallel Rays
| [2020-07-17 16:41:15] |
| John - SC Support - Posts: 40555 |
|
Sorry for the long delay in answering. We were trying to figure out the flipping issue. First, with regards to the trajectories of the lines, the only reason we can find for this is because the option for Chart >> Chart Settings >> Adjust Tool Values to Tick Size is enabled. Refer to the information here: Chart Drawing Tools: Chart Bar Values, Chart Tick Size and Adjusting Tool Values to Tick Size Second, with regards to the Parallel Rays flipping when they are cut, we have figured out why that was occurring and have corrected the issue. This will be in the next Pre-Release (v 2139). For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |