Support Board

Date/Time: Thu, 02 May 2024 13:39:05 +0000

Post From: Replay Processing Speed - Replay not working. Version 1872

[2019-02-10 21:58:35] Link To Thread - Link To Post [Go To First Post]
Sierra Chart Engineering - Posts: 104368
and I notice when I use the accurate replay feature it asks for the processing speed setting. This is because there is a multi-chart back test being performed. If you do not need to perform back testing, then set the Replay Mode to Standard Replay: https://www.sierrachart.com/index.php?page=doc/ReplayChart.html#ReplayMode In this case you will no longer get that prompt. And that type of back testing will not be performed. Also this is nothing new. This has always been there but the problem was is that when you were doing a replay for linked charts only rather than specifying all charts in the Chartbook the prompt was not displaying and it should have been. That was a mistake. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, change to the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2019-02-10 22:07:31