Support Board

Date/Time: Sun, 19 May 2024 12:15:11 +0000

Post From: Converging drawings

[2019-01-02 23:45:00] Link To Thread - Link To Post [Go To First Post]
arruga - Posts: 249
Hi The online manual specifies the exact same steps when there are converging drawings, whether I want to move vs adjust a drawing. "If there are multiple Chart Drawings converging at the point where you left click to select a drawing, then multiple drawings may be selected. These drawings will be drawn with numbers for identification. Enter the drawing number from the keyboard" All good up to here... but then, whether I want to move or adjust, the guide says exactly the same in both cases: "Enter the drawing number from the keyboard, and the drawing move will start after pressing the Enter key on the keyboard." vs "Enter the drawing number from the keyboard, and the drawing adjustment will start after pressing the Enter key on the keyboard." What I want is to adjust, not move, and the above steps result in a move in all cases. How do I get to adjust, instead of move? Let's say I have hztal line overlaying one side of a rectangle, and I want to adjust the line, extending it. I don't want to move the line, but extend it, i.e. pull it form one extreme... How can I select the line? the guide steps causes the line to be in "move" mode. Thanks