Support Board

Date/Time: Sun, 05 May 2024 18:03:36 +0000

Post From: Auto Snap on Point and Figure chart does not snap to the high/low of the bar

[2018-07-13 16:49:37] Link To Thread - Link To Post [Go To First Post]
opmetal - Posts: 65
I draw rays anchored to the high or low of a point and figure bar. I'd like to transition from the P&F study to the "Point And Figure Bar (BoxSize in ticks - ReversalSize)" Bar Period Type but auto snap will not snap to the "point and figure" high or low, it snaps to the underlying bar high or low which is often not the same. This is not the case when using the Point and Figure Chart study, where it correctly snaps to the P&F high or low (and it would be a pain to have to manually adjust the anchors for every ray). Is there a setting for this? Thanks.