Support Board

Date/Time: Tue, 30 Apr 2024 11:14:18 +0000

Post From: Problem with Ray and Parallel Ray on Log Scale

[2018-01-04 22:19:24] Link To Thread - Link To Post [Go To First Post]
John - SC Support - Posts: 31189
We understand what you are stating. Again, this is working correctly. What happens is that the original drawing has a slope that is defined by the two anchor points that are drawn. When the line is extended, the line starts at the end that is not extending and then draws the line to keep the same slope and have the other end extended to the end of the visible screen. In doing so, the line must move off the other anchor point to keep the slope consistent on the Logarithmic scale. Again, the point here is that the decision was made to keep the slope consistent, not the anchor points. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing