Support Board

Date/Time: Sun, 05 May 2024 07:56:52 +0000

Post From: universal renko bars

[2017-11-08 13:21:05] Link To Thread - Link To Post [Go To First Post]
Glenn Infinity - Posts: 103
hi, below is from a user any insight would be helpful, I will be sending you his e-mail because i could not find out how to attach a word document to this post, please check your inbox FYI- I gave the SC Support team some feedback on the new universal renko code today on the support board. Seems they took a step backward with the new code. The old code was closer to the desired operation. They must not be understanding what I’m asking for. Support Board Message: Just checked the universal Renko chart operation for the latest version of code, AT1633 (I had also tried AT1628 last week and saw similar results). I can't seem to find any universal Renko settings that provide the desired operation I'm looking for. I reverted back to the AT1614 code and the operation was much closer to what I desire. I captured some snips of the desired operation vs the SC universal Renko chart operation and summarized this in the attached doc. I also tried to describe the desired operation in more detail after the snips. Please review and comment.