Support Board
Date/Time: Thu, 08 May 2025 05:44:36 +0000
Post From: Selecting Chart Drawings - issue
| [2017-10-31 18:37:10] |
| Marek F - Posts: 244 |
|
Sorry for a mistake. It was about using the Alt key and left click. Alternatively, in a location where there are multiple converging drawings, if you press the Alt key on the keyboard and left click in an area where multiple drawings converge, one of the drawings will then be selected and identified by small circles along the drawing. Repeat this process to cycle through the drawings. In this particular case, release the Alt key and left click again on that same location to perform a Move of the drawing.
It works fine if i want to move the selected drawing using left click, after release the Alt key. The issue there is if i want use eg. the "Cut Drawing Here" from the Chart Drawing Shortcut menu, after release the Alt key. Steps to the issue: 1) Draw first any Line. 2) Draw any Rectangle that overlapping this Line. 3) Using the Alt key and left click, select the Line. 4) Right-click on the Line for select "Cut Drawing Here" from the Chart Drawing Shortcut menu. 5) The selection changes to the Rectangle, and should remain on the Line. |