Support Board
Date/Time: Wed, 14 May 2025 00:18:34 +0000
Post From: TPO Profile Volume Issue
| [2016-05-03 09:41:14] |
| kas64h - Posts: 87 |
|
Hello. I updated to Sierra Chart version 1400 last week, and since then my TPO Profile Charts no longer seem to be working correctly. I split out these profiles to give me areas of liquidity based on Volume, and therefore base both the Value Area and Point of Control on Volume. However, the following settings no longer seem to work: 'Value Area Highlight Based On Volume' and 'Point Of Control Highlight Based On Volume'. If I set both to either Yes or No, the Value Area and Point Of Control DO NOT CHANGE (when clearly they should). I've attached a screenshot (including my settings), to demonstrate this. The Profiles to the left are TPO Profiles with both the 'Value Area Highlight Based On Volume' and 'Point Of Control Highlight Based On Volume' settings set to 'Yes'. The Profiles to the right are simply VbP Volume Profiles. The Value Area and POC for each profile should align, and clearly they don't. It looks to me as though the Value Area and POC are both being based on time rather than volume (as indicated by the 'Value Area Highlight Based On Volume' and 'Point Of Control Highlight Based On Volume' settings being set to Yes). I haven't changed any of my settings since doing the update to version 1400. I've included my settings in case there is something else I need to change since the update. Thank you for your help. |
Private File |