Support Board
Support Board
Search Board
Control Panel
View My Posts / Threads
Direct MessagesDate/Time: Sun, 05 May 2024 19:19:57 +0000
Post From: error message when placing orders
| [2013-07-10 02:35:26] |
| |
|
With this particular scenario, it does make sense you would get the error indicating that there is not a match between the parent order quantity and the Attached Orders because you are reversing. When you are reversing, with Attached Orders, what happens is that there is an order used to flatten the position, and another order to establish a new position with Attached Orders. For the 2nd order with its Attached Orders, it's quantity is 1 in this case. However, your Attached Order configuration consists of 2 targets. This is not going to work. So you need to define another Attached Order configuration that consist of only a single target and stop and save that. You then need to switch to this before you do a reverse. See: https://www.sierrachart.com/index.php?l=doc/doc_AttachedOrders.html#Preconfigured We don't see why you would have a problem like this when increasing an existing position. That does not really make sense, and we need an image of that. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing |