Support Board

Date/Time: Fri, 03 May 2024 23:38:31 +0000

Post From: Angle Unit and Angle Max for Angle Based Gradient are not saved.

[2015-11-23 11:13:25] Link To Thread - Link To Post [Go To First Post]
jesslinn - Posts: 108
Thank you for adding these to the saved settings. Saving works as of 1329, with the following caveats. The problem that I was having from ASCIL, and from the GUI for that matter, is that there appear to be some sort of validation checks, that limit the usefulness of the field. It is not clear what the checking is actually doing. I put a few examples below. The point is that it would be nicer if the values stayed at whatever they were set to, ASCIL or GUI, and the study could then interpret the inputs as it needs to. Set Angle Unit and Angle Max to 0.0 in ASCIL and they change to 0.1,30.0. In the GUI, change the Angle Max to 0.0 and it will change back to 30.0. Change it to 0 and it will change to 0.0 Double click the Angle Unit and it changes to 10000 after which it is possible to set the Angle Max to 0.0 rather than 0. Set them to 0.0 and .0000001 in ASCIL and they stay as zeros, but save the defaults, and the will change back to .1 and 30 on the first use.