Support Board
Date/Time: Fri, 09 May 2025 20:42:54 +0000
Post From: reversals with no position
| [2015-09-29 00:31:14] |
| Sawtooth - Posts: 4214 |
|
Set 'Support Reversals' to Yes, then just use K3 and M3. If you are in a long position, and M3 goes TRUE, it will reverse to short. If you are in a short position and K3 goes TRUE, it will reverse to long. If you are flat, either K3 or M3 going TRUE will enter a new position. You don't use L3 and N3 to reverse. These are used to exit before a reversal occurs, and only if you want to exit based on a formula. Date Time Of Last Edit: 2015-09-29 14:04:37
|