Login Page - Create Account

Support Board


Date/Time: Wed, 18 May 2022 14:13:35 +0000



Post From: manually move multiple stop orders on chart

[2013-06-10 18:00:48]
cross - Posts: 70
I have 3 targets (scaling out). There are Attached Stops assigned to their target counterparts (OCO Group 1..3, moving to BE and trailing for the 3rd position).

As I see I can use
- one stop for all targets (All OCO Groups) OR
- same number of stops as targets (OCO Group 1..x)
but cannot mix both.

After some move the remaining stops stay at the same level and I expect to move them manually all-in-one (occasionally) but suddenly realize that I move only one of the stops at a time.

I understand that this is not an error but I'm looking for some ease of clicks :)

Thanks!