Support Board
Date/Time: Sun, 09 Nov 2025 01:08:06 +0000
Post From: drawing support
| [2015-03-03 11:12:34] |
| navigator - Posts: 27 |
|
When I draw parallel lines I have all the options checked, enable vertical lines, mark anchors, extend forward, allow horizontal shift. This will show me the dots that I have to connect with a ray or line to draw the midline of the parallel lines. Unfortunately when I switch tools from parallel rays to a line or ray to draw the midline, the dots will disappear. I need those dots to remain while I switch tools. How is that done? Or is there another way of drawing the midline between parallel lines. Thanks
|