Support Board
Date/Time: Mon, 14 Sep 2026 23:49:15 +0000
Post From: 10 Copies of Sierra
| [2026-09-14 19:37:33] |
| John - SC Support - Posts: 47889 |
|
In the end, how you set this up depends on where you want to get your data from, as that is the limiting factor, at least in terms of account setup. If you feel there are issues with the computer performance, then that is something different. If you want to get your data from our Denali Exchange Data Feed, then you would need to have 4 separate VMs and 2 different Sierra Chart accounts. You would have 3 installations on each VM except for the last one which would have 1 (3 + 3 + 3 + 1 = 10) - you could change this, but the point is that you can have a maximum of 3 installations per VM. And you need the two different Sierra Chart accounts due to the restriction of only being able to get data to two different computers at the same time. Keep in mind that even for that, you have to pay a second set of exchange fees. -- If you want to get your data from Rithmic, then you have much more flexibility for the setup. But then you are limited by Rithmic's data. Since these are separate Rithmic accounts, we assume you can get the data to each installation without any issues from Rithmic. That is something you would need to double check with them. In this case, you can have as many installations on a single computer that you want. So you would only be limited by the Sierra Chart number of computers that you are allowed. This is 2 for your current package (Package 10), but is 3 if you change to Package 11. So you could have 3 different computers running the number of installations you want each getting data from Rithmic. In this case you do not need any extra Sierra Chart accounts or anything special from us. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |