Support Board
Date/Time: Sat, 01 Aug 2026 13:26:11 +0000
Post From: Cannot Find Candle Wick Width Settings
| [2026-06-18 14:26:20] |
| John - SC Support - Posts: 47426 |
|
1. Sierra Chart does save the positions of the charts, so you should have the charts going back to where they were when you set them up. Although we do not understand what you mean by "using the monitor's window management features". We wonder if this somehow is not giving the correct information to Sierra Chart so that it is not aware of the positions of the windows. Try moving the charts to the respective monitors and setting them up "manually", then save the chartbook, close it, and reopen it - the charts should be in the correct positions. 2. If you are using a scale range of "Automatic", then the candles will fill in automatically into the available area. If you move them, then they will stay relative to that new position. You can reset the scales by following these instructions: Chart Scale and Scale Adjusting: Resetting the Scale But there are a few different scale range options, so depending on what you are using, it could be that what you are seeing is correct for the way that scale is setup. You need to determine what works best for you. Refer to the following: Chart Scale and Scale Adjusting: Scale Range (Scale Settings) For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |