Support Board
Date/Time: Thu, 23 Apr 2026 01:28:58 +0000
Post From: ACSIL BuyEntry always returns -1 when connected to Rithmic/Bulenox in Trade Simulation Mod
| [2026-04-22 21:30:09] |
| John - SC Support - Posts: 45738 |
|
When you have "Trade >> Trade Simulation Mode On" enabled, then you are specically in Trade Simulation Mode and it does not matter what service you are connected to. At that point, you are using the built-in Sim# accounts. The Simulation accounts do NOT show in the "Trade Account Monitor". Refer to the following: Overview of Trading: Difference between Simulated and Non-Simulated Trading Modes You can control how many simulation accounts there are, each one having the word "SIM" and then a number after it. Refer to the following: Global Trade Settings Windows: Number of Simulation Accounts (Global Settings >> General Trade Settings >> General) Therefore, you need to be selecting one of the Sim# accounts that you have available. Sim1 should work fine. You also need to set sc.SendOrdersToTradeService to 0 since you are not sending to the live trading service. Refer to the following: Automated Trading Management: SendOrdersToTradeService Make sure you have the above setup properly. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |