Support Board
Date/Time: Fri, 20 Mar 2026 04:48:14 +0000
Post From: Trig & Trail OFFSET NOT UPDATING in Triggered Trail Stop (Spreadsheet + Attached Orders)
| [2026-02-02 16:48:48] |
| John - SC Support - Posts: 45204 |
|
This statement is not correct: When using Attached Orders Windows with Target1 + Stop:Stop
the Offset value pulls from Spreadsheet and works perfect When you have a Target/Stop offset entered in the Spreadsheet, and you enter an order FROM the spreadsheet, then the Target/Stop will be set based on the offsets entered in the spreadsheet, not from the Trading Window. If you enter an order from the Trade Window, then the offsets will be taken from the settings for the Trade Window. If you enter an order from the Spreadsheet, but have not specified any offsets, then the Attached Orders will come from the Trade Window. Therefore, to do what you are wanting is not supported, nor is it supported in any way at this time. You would have to use ACSIL to access information entered in the Spreadsheet to use as settings for a Triggered Trail Stop. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2026-02-02 21:10:30
|