Support Board
Date/Time: Thu, 11 Dec 2025 03:58:41 +0000
Post From: Attached orders in chart trade window: Two contracts, but only one gets stopped out.
| [2025-12-08 22:54:40] |
| John - SC Support - Posts: 43413 |
|
You must not be setting up the Stop order properly. You need to set the Stop to be an OCO group of "All OCO Groups". The system will then set the quantity for that Stop to be the total that is set. Refer to the following for an example (you can ignore the "Move to Breakeven" options in the example): Attached Orders: 2 Targets and Common Stop with Move to Breakeven on First Target For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |