Support Board

Date/Time: Mon, 16 Jun 2025 09:31:03 +0000

Post From: Programmatically accessing the Point and Figure box levels

[2025-05-15 15:17:48] Link To Thread - Link To Post [Go To First Post]
pa_trader - Posts: 36
Here is an explanation of what I'm looking. I've shown a PnF chart (boxSize=8ticks, reversal=1), plotted both PnF X and O, and as a Candlestick chart. Bar High is 5905.5 and Bar Low is 5896.75, but the actual PnF box levels are 5905/5903/5901/5899/5897. The 0.5pt above the 5905 box and 0.25pt below the lowest box were incomplete boxes. So basically, is there a way to access these through ACSIL, without replicating the full logic to calculate these ? Its similar to Renko Closes, in the sense that once the chart is set, then the boxes can only occur on certain levels that are 8 ticks apart


Attachment Deleted. PnF Box levels.PNG / V - Attached On 2025-05-15 15:17:35 UTC - Size: 37.96 KB - 84 views