Support Board

Date/Time: Sun, 05 May 2024 13:29:16 +0000

Post From: GANN SQUARE A HIGH/LOW

[2014-08-06 17:43:59] Link To Thread - Link To Post [Go To First Post]
michelh - Posts: 159
Basically, I want to select a single point (and not a range like the tool forces you to select) and to have Gann angles projected from that point. I do not want to square a range. I want to select a single point. The addition of this to SC would allow users to square a high/low and to square a range (the latter is already there but not the former)