Support Board

• Support Board |
• Search Board |
• Control Panel |
• View My Posts / Threads |
• Direct Messages

Date/Time: Sun, 11 May 2025 00:37:29 +0000

Post From: Tool Config - Show End Point Price

[2024-09-25 12:58:30] Link To Thread - Link To Post [Go To First Post]
Benutzer4711 - Posts: 38
Hello When setting up Tool Configs the Setting for Show End Point Price stay at "No" all the time. When using the Tool the Price is actually shown, but its not clear when this setting is set to Yes based on A) Apply All or B) Save Config That's affecting Horizontal Lines + Horizontal Rays. Please check on this. Thanks Date Time Of Last Edit: 2024-09-25 14:08:55
0x Thank you
Tool Config Window.jpg / V - Attached On 2024-09-25 12:56:00 UTC - Size: 336 KB - 69 views