Support Board

• Support Board |
• Search Board |
• Control Panel |
• View My Posts / Threads |
• Direct Messages

Date/Time: Sun, 11 May 2025 14:42:22 +0000

Post From: The Zig Zag and the Zig Zag Cumulative Volume

[2014-07-24 17:24:05] Link To Thread - Link To Post [Go To First Post]
markuz - Posts: 90
The Zig Zag and the Zig Zag Cumulative Volume 'forgets' its parameter. I have set the parameter 'Input Data for High' to 'Last' And the 'Input Data for Low' to 'Last' and it works OK for some minutes but then the function starts using the High/Low value as you can see in the picture below. I believe this is wrong. I hope Sierra can fix so I dont have to reset the chart over and over again. I', using version 1157.
1x Thank you
zig zag 1.bmp - Attached On 2014-07-24 17:23:47 UTC - Size: 1.09 MB - 499 views zig zag 2.bmp - Attached On 2014-07-24 17:23:52 UTC - Size: 994.53 KB - 642 views