Support Board
Date/Time: Sun, 25 May 2025 14:50:19 +0000
Post From: Spreadsheet for Trading doesn't fill Order
| [2023-06-05 18:04:25] |
| John - SC Support - Posts: 40015 |
|
Keep in mind that in any situation (including replays), the order is only going to be entered for the current bar. What you show in your image are values of 1 for previous bars. So those are situations where an order could have occurred, but if the spreadsheet system was not running at that time, then that would not generate a live order (again, only on the current bar will an actual order be sent to the trading service (or simulated)). If the issue is that you are not getting those same results during a replay, then you would need to look at the type of replay (or backtesting) you are running. Refer to the following: Auto Trade System Back Testing: Differences Between Back Testing and Real-Time Auto Trade System Evaluation There are other items on the page above that might be helpful as well, so take a look. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |